—With the growing concern of climate change and global warming, the reduction on carbon emissions of supply chain activities have been increasingly focused by both academics and corporates in the last two decades. The increased public awareness on sustainability and stricter environmental policies together enforce the companies to rethink their practices in supply chain design and operations in an ...

TARGET is a collaborative project involving a partnership of universities and institutes of higher education in UK, Ireland, Norway, Finland and Sweden. The project will develop tools to enhance capacity in regional manufacturing companies to adapt and embrace new technologies and innovation. This is to be done in collaboration with small/medium sized manufacturing engineering companies - developing, ...

The study of the network design problems related to reverse supply chain and reverse logistics is of great interest for both academicians and practitioners due to its important role for a sustainable society. However, reverse logistics network design is a complex decision-making problem that involves several interactive factors and faces many uncertainties. Thus, in order to improve the reverse ...

The location problem of treatment and service facilities in municipal solid waste (MSW) management system is of significant importance due to the socioeconomic and environmental concerns. The consideration of waste treatment costs, environmental impact, greenhouse gas (GHG) emissions, social fairness as well as other relevant aspects should be simultaneously taken into account when a MSW management ...

With the increase of the concern from the public for environmental pollution and waste of resources, the value recovery through reuse, repair, remanufacturing and recycling from the end-of-use (EOU) and end-of-life (EOL) products have become increasingly important. Reverse logistics is the process for capturing the remaining value from the EOU and EOL products and also for the proper disposal of the ...

Non steady state thermal conductivity of ABS was estimated using an analytical approach in a Cold Climate Chamber at ?10?C and ?14?C. Two hollow cylinders of ABS of varying thickness were used to estimate the conductivity. The material was porous but the porosity was unknown. This paper is a case study to understand, if it is reasonable to estimate the thermal conductivity using the analytical varying ...

Nowadays the concept of Industry 4.0. and the relating intelligent manufacturing system are getting more and more current and well-known. In the past years the outstanding development of different areas such as information technology computer science, machining, robotics and so on, made possible a comprehensive transformation of the manufacturing systems. Present paper aims to give a general overview ...

Numerical study of atmospheric ice accretion on two non-rotating circular cylinders in tandem arrangement was carried out at different operating and geometric conditions. To validate the numerical model, initially the results of ice accretion on single circular cylinder were compared with the experimental data obtained from CIGELE atmospheric icing research wind tunnel (CAIRWT) [1, 2]. A good agreement ...

Water hammer phenomenon involves the transformation of kinetic energy in pressure energy, this transformation occurs as the fluid conditions change inside the pipe in quite a short time. Industry requires to affront frequent flow interruptions in pipe systems due to the closing of valves or stopping of pumping equipment. This phenomenon can initiate serious damages like destruction of the pipe system ...

The application of capacitive sensing technique is widely distributed in different physical domains primarily because of the diversity in dielectric permittivity and due to its minimum loading error and inertial effects. Atmospheric ice is a complex mixture of water, ice and air which is reflected in its complex dielectric constant. There are many existing atmospheric icing sensors but only few are ...